Professional PCB manufacturing and assembly
Building 6, Zone 3, Yuekang Road,Bao'an District, Shenzhen, China
+86-13923401642Mon.-Sat.08:00-20:00
TAG:

ircuit board

Circuit board machining small aperture

When wet, the solder can flow and expand freely on the wire and pad to form adhesive connection.

Circuit board processing circle should be how to plate

In addition, this capacitor should be purchased with a relatively large volume, and those with a small volume should also be marked 50V4700uF as far as possible.

Tianjin circuit board factory

All digital logic circuits can be simplified by the above three kinds of circuits, that is to say, a circuit can be composed of NAND or NOR circuits. Let's take a look at their characteristics to deduce the characteristics of digital CMOS circuits.

Install PCB circuit board anti-ESD design

In order to eliminate electrostatic discharge (ESD) interference and damage to electronic equipment, it is necessary to take a variety of technical measures to prevent.

Circuit board processing we provide material loss

The rectifier tube QL for bridge rectifier uses a 15-20A silicon bridge, which is compact and has a fixing screw in the middle, which can be directly fixed on the aluminum plate of the housing for favorable heat dissipation.

4 layers of circuit board processing

it is difficult to accommodate the software used for debugging procedures, so to debug the microcontroller software, the use of microcontroller simulator.

What does circuit board processing open steel mesh mean

With Spectre circuit simulation platform, WillSemi maintains design integrity throughout the design cycle, increasing simulation throughput and improving productivity.

Circuit board processing several times pressing

Single chip emulator is a set of hardware device specially designed and manufactured for the purpose of debugging single chip software.

Dongguan Longxiang circuit board processing

The overall structure of the electronic responder is shown in Figure 1. It includes identification and latching module, timing and foul setting module and scoring module.

laser circuit board processing parameters

Use screws with built-in washers to achieve tight contact between the PCB and the metal case/shield or ground surface bracket.

Ranking of Chinese circuit board processing enterprises

the production cost is not too much, other electronic components without requirements, after installation without too much adjustment can work normally.

PCB design: Analysis of quality problems in electroplating and etching of printed circuit boards

The lines form "copper roots" on both sides after etching, and the copper roots narrow the line spacing, resulting in printed circuit boards that do not meet the requirements of Party A, and may even be rejected.

Just upload Gerber files, BOM files and design files, and the KINGFORD team will provide a complete quotation within 24h.