Introduction to copper plating technology of PCB circuit board in electroplating process
The effect of horizontal perforation electroplating in machining multilayer circuit boards is far inferior to that of vertical perforation electroplating.
The effect of horizontal perforation electroplating in machining multilayer circuit boards is far inferior to that of vertical perforation electroplating.
he system speed can be greatly reduced because of the increase of delay time caused by the delay of 2ns per 30cm line length of the common interconnect on the baseboard. Image shift register synchronization counter.
The deformation of the circuit board (PCBA board) usually comes from the rapid temperature rise and rapid temperature drop (thermal expansion and cold contraction) caused by Reflow。
usually in the process of high-speed PCB design, the seemingly simple holes usually bring great negative effects to the circuit design.
The cost calculation of PCB industry is the most special and complex in all industries. From opening, platen, forming, to FQC, packaging, completion and warehousing.
in fact, repair maintenance cost greatly increased at the same time, customer brand affected, It doesn't pay off in the long run.
the temperature reproducibility can be obtained through multiple tests, so as to systematically evaluate the performance of the press.
Electrical testing is a very important link in the PCB board manufacturing process, the purpose is to check whether the PCB board is open and short circuit problem, to ensure that the finished products in line with the customer's electrical performanc
For electronic equipment, a certain amount of heat will be generated during work, so that the internal temperature of the equipment will rise rapidly.
In this process, all surface areas and boreholes are plated with copper, some resistance is poured on the surface of the unwanted copper, and then etching resistance metal is plated.
PCB circuit board fault detection methods: 1, determine the fault location, 2, detection equipment, 3, visual and physical detection, 4, special detection components, 5, on the circuit board for detection, 6, low voltage measurement
This article focuses on conductive holes, keyholes, and the connection between Protel 99 SE/pads/ and CAM350 geber files Conductive holes: via keyholes: pad is particularly prone to several problems