Some basic testing and inspection tasks may be required to be performed on your PCB/PCBA during the manufacturing and assembly process, and it is recommended that these tests be performed, at the very least, to ensure continuity, accurate assembly, and si
Quality control in mass production and prototyping has a common set of important tasks: the need for PCB testing. The specific set of tests you need to perform in a PCBA depends on its application area, desired service conditions, and, of course, the rele
An extremely important guideline is that the layout should start with a basic floor plan of the components on the development board. This will allow you to stratetize how to divide the different circuit areas on the board to avoid overlapping analog and d
Manufacturing dry film for PCB is a difficult task that must be carried out in strict clean room conditions using a dedicated coating line. Such facilities are usually dominated by a few large companies
The heat generated by the IC is transferred from the device to the copper layer of the pcb. The ideal cooling design will make the entire circuit board the same temperature.
Most of the existing sites of manufacturers are small, and the investment amount is also relatively large, so that many small and medium-sized PCB enterprises to introduce robots to complete the automation hope and stop.
Again, these designs can be completed on schedule and within budget while meeting the design requirements. Designers need to consider the necessary documentation, pcb design steps and strategies, and final inspection.
The components in the circuit module should adopt the principle of nearby concentration, and the digital circuit and the analog circuit should be separated at the same time.
A common problem is that the circuit schematic is correct, but it doesn't work, or only operates at low performance. I'll show you how to properly lay out the circuit board of an op-amp to ensure its functionality, performance, and robustness.
Development times must be as short as possible, so these competitors have little warning that new products will appear that they need to analyze, understand, and copy to make this window larger.
There are two main variants to consider, linear power supplies and switched mode power supplies. These are all challenges for PCB layout.
No matter how developed the market is, PCBS are the most frequently used demand in production and an integral part of the electronics industry.
Telegram